Water leaks in you home or business can be annoying and costly.
The sound of a faucet dripping or a toilet running in the night can mean your hard earned dollars are slipping away down a drain. A water leak as small as a pinhead can waste about 25,000 gallons of water a month. That could mean an additional water and sewer cost of $130 on your City Utilities' bill with no benefit to you.
Water leaks can be simple to find and fix and the benefits to your pocketbook and your sleep can be huge. Here are some tips and resources for finding and fixing water leaks:
Get to Know Your Water Meter
Your water meter is a great tool for helping you determine if you have a water leak. Most water meters have a small red triangle that spins when water is going through the meter. Find your water meter and look at it when you are sure no water is being used in your home. If the red triangle is spinning and you know you are not using water, it is very likely that you have a leak.
A constantly dripping faucet wastes about 15 - 20 gallons of water a day -- water you pay for! Faucets usually drip or leak because the seals, washers or O-rings inside are worn. Replacing the pieces that help seal the faucets is relatively easy and there are many on-line resources that can help you see exactly what to do based on your faucet brand and configuration.
Here's just one video that shows you what to do to fix a faucet with two handles.
If you're not a do-it-yourself type, you may want to call a plumber to do the job. You could save the cost of the repair in just a few months of lower water bills.
The toilet is the most common household water waster but it may not be as noticeable as a dripping faucet. There are two main areas where toilets typically leak.
At the bottom of the tank is a flush valve that opens when you flush to allow water to move from the tank into the toilet bowl. If this valve does not close completely after the flush, water can continue to flow slowly into the bowl. The siphon mechanism that makes the flush happen ensures that the bowl does not get too full and overflow. Your toilet may appear to flush itself from time to time. But this also means that water that leaks from the tank into the bowl will move into the sewer system. This water is being wasted.
To find out if the flush valve is leaking, put a few drops of food coloring into the toilet tank. Wait 10 minutes then look in the toilet bowl. If the water in the toilet is colored, the flush valve is leaking. Be sure to flush the toilet immediately after doing this test to be sure the food coloring does not stain the inside of the tank or the bowl.
A leaking flush valve can be repaired with advice and parts from a hardware or home improvement store. Click here for more information
Toilets may also run when the water level in the tank is too high because of a float that is not properly adjusted. The tank fills with water through a fill valve. The fill valve is controlled by a float which may look like a ball on an arm or like a plastic cup that floats up and down on the valve. When the water level in the tank gets too high, the excess water will escape through an overflow tube into the toilet bowl. Ideally the water level in the full tank should be 1 to 1 1/2 inches below the top of the overflow tube. If the tank is getting too full, you need to lower the float level. On top of the fill valve there will be a screw that attaches the float arm to the fill valve. You can adjust the height of the float by turning the screw. Turn the screw by quarter inches until the water level is correct.
A float cup on the fill valve is adjusted in much the same way. There will be an adjustment screw on the top of the fill valve. When you turn the screw, this will adjust the height of the float. Turn the screw a quarter of a turn counterclockwise to lower the float cup. Flush the toilet to see if the adjustment is correct. If the water in the tank is still too high, turn the screw another quarter of a turn.